Phil Zarrow, ITM Consulting With over 35 years experience in PCB assembly, Phil is one of the leading experts in SMT process failure analysis. He has vast experience in SMT equipment, materials and processes.
Jim Hall, ITM Consulting A Lean Six-Sigma Master Blackbelt, Jim has a wealth of knowledge in soldering, thermal technology, equipment and process basics. He is a pioneer in the science of reflow.
Comments» Use the form below to submit a comment.
While the original question may have had more information, I see nothing to show that RM was using scored-both-sides panels. We have many panels where divisions are cut clear through (routed), leaving short support tabs. These, in turn, have a hole pattern to control break location. I developed the pattern for a board where the break HAD to be sub-flush due to clearance issues. Hand de-paneling works fine IN THIS CASE - but the karate-chop would probably not.
Sunstone Circuits, has released the newest version of their design software, PCB123. Bottom line, the design process just got easier. Sunstone Circuits
Once you have made the decision to package your electronics with rigid flex, it makes sense to pick a production partner who can build it right. Printed Circuits, Inc.
Solve manufacturing challenges while networking with hundreds of exhibitors and thousands of peers focused on design, manufacture, assembly and test. Keynote by William Shatner. IPC — Association Connecting Electronics Industries
There's simply no reason to scrap circuit boards when they have contacts contaminated with solder. Restore them using the Gold Contact Plating Kit. CircuitMedic
Once you have made the decision to package your electronics with rigid flex, it makes sense to pick a production partner who can build it right. Printed Circuits, Inc.
Use the form below to submit a comment.
Ronald G. Darner, Mortara Instrument, Inc.